Page 3 of 3
Re: Twist of the position of the hulls to each other
Posted: Thu Feb 26, 2015 8:56 am
by Vitaliy
If I correctly understood, on a photo the plate is welded on the plug. It isn't absolutely correct. Loadings in that place the big. You watch that the detail didn't burst on a seam.
Re: Twist of the position of the hulls to each other
Posted: Fri Feb 27, 2015 8:47 am
by KlabauterR
Hello Vitaliy,
do you believe that the seam itself is not strong enough? It was welled by a professional. Do you have any idea, how I could test the seam?
Ralph
Re: Twist of the position of the hulls to each other
Posted: Fri Feb 27, 2015 2:50 pm
by Vitaliy
Force vector at the movement on waves can change. In this case your detail will work not correctly. Can start breaking off it. But, perhaps, durabilities of a seam will be enough and the detail remains whole. You needed to do a detail similar on original, but with the increased shelf for fastening of screws.